Technical Data Sheet - Sealer 10
Product Name
Touchstone™ Sealer 10
Manufacturer
Bonstone Materials Corporation
Product Description
Touchstone™ Sealer 10 is a no-sheen, natural-look, solvent-based penetrating
sealer formulated to provide maximum stain protection, especially in
food preparation
and serving areas. May also be used as a pre-grouting sealer over clean stone
surfaces a minimum of 6 hours prior to grouting. Allows moisture vapor transmission.
Basic Uses:
- Recommended for use on all natural stone where a natural look
is desired.
- Equally effective for interior and exterior applications.
Limitations:
- Do not allow sealer to come in contact with any non-recommended
surface
- May slightly lighten or darken some stone surfaces
- Sealer will not prevent
surface wear or etching from acids or caustic chemicals
Technical Data
Cure Time:
- Allow a minimum of 30 minutes drying time between coats.
- Ready for surface
traffic in 2 hours.
- Keep area dry for 12 hours.
- Achieves a full cure in 24 hours.
- After two hours conduct a test to determine if surface is completely
sealed by applying water droplets to the surface. If water is absorbed,
apply an additional coat. Wait 2 hours and repeat the test
Application
General Instructions
- Read entire label before using
- TEST A SMALL AREA according to application
instructions, with a 24-hour cure
time to determine results. Test for stain repellency using likely contaminants.
- For
new installations sealer can be applied 48 hours after grouting.
- Surface
must be clean, dry and free of existing sealers or coatings.
- Apply 1 to
3 coats using a applicator, natural-bristle brush, paint pad, white
cotton towels or solvent-resistant sprayer. One coat should be
sufficient for
most dense surfaces.
- Using absorbent white cotton towels, polish dry any sealer
that does not penetrate
into the stone within 3 to 5 minutes of application.
Surface Preparation & Use:
Expected wear will depend on hardness and texture of surface, type of
area, surface wear, frequency and type of maintenance products used.
The expected wear is up
to 10 years. Extreme weather conditions, harsh cleaning methods and high-alkaline
or solvent-based cleaners will affect wear.
Coverage:
Approximately 400 to 1,500
sq. ft. (37m2 to 140m2) per coat per gallon (3.875L),
depending on type of stone, porosity and texture of surface, temperature,
humidity and method of application.
Availability
Packaging
Touchstone™ Sealer 10 is available in pints, quarts, gallons, 5-gallon
pails
and 55-gallon drums.
Storage
Close container after each use. Store in original container only. Store
and use in temperatures between 40°F and 100°F. Unused, stored
product is freeze-thaw
stable.
Warranty
This product’s warranty is limited to replacement of defective
material and freight charges to destination only. Bonstone Materials
Corp. is not responsible
for consequential damages.
Caution
- Keep out of reach of children.
- Combustible
- Contains petroleum distillates
- Use in well ventilated areas
- Avoid prolonged skin contact
- Wear organic vapor respirator, solvent-resistant
gloves, safety goggles and protective clothing.
- IF INGESTED: Do not
induce vomiting. Drink 1 to 2 glasses of water. Call physician immediately.
- EYE
CONTACT: Flush with water. If irritation persists, seek medical attention.
- SKIN
CONTACT: Wash immediately with soap and water. If irritation persists,
seek medical attention.
- INHALATION: Relocate to fresh air. If symptoms
persists, seek medical attention.
<Back | Top | Home
|
